Specifications

104/156
Q25M Camera Manual: Installation
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
Connecting the Patch Cable to an MX-Overvoltage-Protection-Box, an MX-NPA-Box
or a Standard Network Outlet
To establish the network connection of the camera using an
MX-Overvoltage-Protection-Box or an MX-NPA-Box, remove
the blue bayonet catch and the blue sealing plug from the
right-hand side of the box. Insert the MOBOTIX patch cable
into the box and fasten the cable using the blue bayonet catch.
For additional‚ information on how to install an
MX-Overvoltage-Protection-Box or an MX-NPA-Box , open
the Products> Accessories> Interface Boxes section on
www.mobotix.com.
When using a standard network outlet (only for indoor installations), insert the MOBOTIX
patch cable of the Q25M directly into the network outlet.
If additional cables are required inside the housing, they must be connected as described
in
Section 2.9.6, «Connecting a USB Cable» and Section 2.9.7, «Connecting a Two-Wire
MxBus Cable»
.
2.9.3 Power Supply Using a Switch
1. Connect the factory pre-installed cable of the camera to the camera connector of
the PoE adapter.
2. Connect the LAN/Power connector of the PoE adapter to the Ethernet connector
of the switch/router or the Ethernet port.
3. Plug the RJ45 connector of the power supply unit into the PC/Power connector
of the PoE adapter.
Patch cable
IP addresses in the
gure are shown only
as an example!
Switch/router
PoE adapter
Power supply
LAN/www
PC
(10.8.0.11/255.0.0.0)
Camera
(10.8.0.99)
LAN/Power
PC/Power
Camera
RJ45
RJ45
RJ45