User manual
© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
94/126
MxEasy User Manual: System Configuration
3. Select whether a doorbell ring at the Door Station should be answered
– Without ringing at the remote station
The remote station does not respond; residents are therefore not informed of the
ringing doorbell.
– With a ringing and a message for visitors if the resident does not answer
The resident is informed of the ringing doorbell. If the homeowner does not respond
after a specified period of time, then a message is played at the Door Station and
the visitor can leave a message.
– Only with a message for the visitor
If a visitor rings the doorbell at the Door Station, then a message is played and the
visitor can leave a message.
4. If the ringing and message profile was previously selected:
– Now select a remote station or enter a new remote station that will indicate when
the doorbell at the Door Station is rung.
If you select MxEasy as remote station, the IP address of the computer on which
MxEasy runs must be entered or selected. For a Voice over IP call, either a SIP
number or an IP address for the VoIP telephone to be called must be entered or
selected, depending on the configuration.
– Select how much time should elapse without the doorbell being answered before
a message should be played to the visitor.
– Select a message that should be played to the visitor.
– Activate the checkbox Record Message if the visitor should have the option of
leaving a message.
5. If the message only profile was previously selected:
– Select a message that should be played to the visitor.
– Activate the checkbox Record Message if the visitor should have the option of
leaving a message.
6. Click on OK to confirm.
Changing Door Station Hardware
If changes occur in the hardware equipment of your Door Station, such as an upgrade
of the door sensors or bell buttons, then these changes must also be entered in MxEasy.
1. Select the “Equipment“ tab.
2.
Select the number of doorbells that will actually be used (e.g., Siedle bell button module
with 1–4 buttons) without including the fixed bell button on the camera module and
the bell button on an existing keypad in the count.
3. Activate the desired checkbox.
– Door position sensor and door lock switch: