User manual

© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • [e-mail]
28/126
MxEasy User Manual: Installation And Initial Operation
Change Camera Access
1. Proceed as described in
Section 2.2.2 “Selecting And Connecting New Cameras .“
The door camera is reconfigured.
2. Click on the Continue button. If automatic configuration was run before the camera
was integrated, the “Specify Door Station Equipment“ window opens (see further below).
If automatic configuration was not run, then the “Automatic Configuration“ window opens.
Start Automatic Configuration
1. Click on the Start Door Station Configuration button. The
system searches for existing Grandstream IP telephones and
other Door Station cameras. The Door Station modules found
are listed in a “Phone Device Selection“ overview.
2. Select the Door Station modules that should be integrated into the
system. Click on OK. This starts the automatic configuration. This might
take several minutes. The “Initialize Keypad“ window opens.
3. Now enter the supervisor PIN on the Door Station Keypad and train in
the admin card (see T24 System Manual, Part 2, Section 2.2 “Setting Up
The Keypad“).
4. Next, click on the Keypad Trained button. The “Specify Door Station
Equipment“ window opens.