User manual
www.mobotix.com • sales@mobotix.com
To select more than one camera, simply use Shift-click for a
block selection or
ctRl
-click for individual selection. Right-
click a selected camera to call up the pop-up menu for that
camera. Using the Add command, you can add cameras that
are not already included in the list (for example, a remote
camera over the Internet).
• Click one of the columns to sort the camera list by name. You can change
the order in which the cameras are sorted by clicking again. Double-click the camera
name to change it or click Edit in the pop-up menu.
• You can enter any fi lter criteria in this fi eld to narrow the list of cameras
displayed (for example, if you enter
3.4.4.7, the list will be narrowed down to the
cameras that use that particular software version).
• There are fi ve statuses that MxEasy cameras can display. These statuses
are shown by the colored circles listed before the names of the cameras (see box
Possible Camera Statuses
).
The camera is responding and can be integrated immediately.
The camera can be integrated, but it is password-
protected and the password has not yet been entered into MxEasy. Right-click
the camera, select Authenticate, and enter the correct user name and pass-
word. Once a valid user name and password have been entered, the symbol
changes to a green circle and the lock disappears.
The camera has been found on the network, but it needs to be adjusted
to the network confi guration of the MxEasy computer. This is the default status
for cameras with factory settings. Later, the Assistant will be able to confi gure
these cameras automatically.
The camera has been found, but it cannot be integrated at this time.
This is the case if MxEasy is busy determining the status of the selected cam-
era, for example. The yellow circle will be replaced by a green or red circle
after a short time.
The camera has been found, but is not responding. This can be caused by
a disruption in the HTTP connection (network error, fi rewall, etc.), for example.
• MxEasy displays the live images from the selected camera in this fi eld (if
more than one camera is selected, the preview window displays the images from
the last camera to be selected).
If all the desired MOBOTIX cameras are in the video source list, you can proceed
to
Section 2.2.2, Adding New Cameras
. Cameras with the status can be
reconfi gured for the "proper" subnet, as described in the following section.