User manual
www.mobotix.com • sales@mobotix.com
• 1 , 1 MOBOTIX Network Power Adapter, 1 MOBOTIX
for supplying power to eight cameras (or a PoE switch with at
least nine PoE ports)
• Additional switch with at least ten free ports
• Uninterruptible power supply (UPS) units for supplying the cameras and the switch
• Professionally laid Ethernet cables guided through to the mounting positions of the
cameras (no separate power cables required)
• Computer installed with a Windows, Macintosh or Linux operating system
For more information, see
Section 1.5, Installation Procedure
and
Section 1.6, How Can I
Expand My MOBOTIX System?
We will describe the most important steps for basic installation in this section. These
steps are the same for all scenarios. Steps that apply to only one of the scenarios are
correspondingly indicated by symbols in the margins.
For thorough instructions regarding camera installation, see Section2
Installation
in the
corresponding
camera manual
. For information on the power supply and connecting
cameras to the network, see the section
Connecting the Camera to the Network and to
the Power Supply
in the corresponding
camera manual
.
•
Determine where you want
to mount the cameras. Run the Ethernet cable to the mounting position of the camera.
Mount the cameras and connect the Ethernet cable to the corresponding camera:
• In the House example, one camera (Q22M) is mounted over the front door and
the other camera is mounted behind the house under the roof overhang.
•
In the example, one D22M-Sec monitors the pumps in order to record
persons and vehicles in the area. The car wash cameras are mounted at the
entrance and exit of the car wash and the shop camera is mounted in the corner
of the shop space. The register camera is mounted on the ceiling above the cash
register area so as to monitor both customers and the register.
• In the example, one Q22M-Sec is mounted at the main entrance of the
hotel and the corresponding ExtIO is mounted next to the door of the main
entrance where it serves as a door intercom. Two M22M-R16 cameras monitor
the entrance and the back side of the underground garage. The remaining five
Q22M-Sec cameras are installed in the planned positions using In-Ceiling sets
(in the hallways of the second and third floors, in the swimming pool area, in the
gym and above the reception desk). The camera mounted above the reception
desk is mounted in the ceiling so as to monitor the entire reception area.
• Set up the power supply of the camera. Use either a
commercial PoE switch, MOBOTIX Network Power Racks/Boxes, or MOBOTIX power
in conjunction with Network Power Adapters.