User manual

63
© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • [e-mail]
63/144
Recordings And Alarms
• Passive infrared: A PIR sensor (passive infrared sensor) is either installed standard
in MOBOTIX camera models or the PIR of a connected MOBOTIX ExtIO can be used.
The PIR sensor enables motion detection even in the dark.
Open the shortcut menu via the Passive Infrared Detection button and select the desired
recording mode. The lower the selected trigger level, the more sensitive the detection.
• Noises: Noises can trigger alarms. Noise detection is done by the integrated camera
microphone or by the microphone of a connected and activated expansion module.
Open the shortcut menu via the Noise Detection button and select the desired trigger
level. The lower the selected trigger level, the more sensitive the detection.
• Signal input: An external device – such as a light barrier, for example – can deliver
an electric impulse to the camera that qualifies as an event and triggers an alarm.
Such devices can be connected to the existing signal input (SI) on the camera or that
of a connected expansion module.
Open the shortcut menu via the Signal Input Detection button and select the desired
status or status transition in the SI signal to trigger an event.
• Door Station: If a T24 Door Station is connected in MxEasy, then the Door Station
Events button will be shown instead of the Signal Input Detection button. This enables
the triggering of alarms when the doorbell is rung, for example.
Open the shortcut menu via the Door Station Events button and select the desired
option. Dierent options will be available, depending on the Door Station model. If,
for example, you use a Door Station with a keypad, then you can set the system up
to trigger an alarm and even a notification if someone enters an invalid PIN code or
an invalid RFID.
• Temperature: Temperature changes that can be registered by the camera's internal
temperature sensor trigger alarms.
Open the shortcut menu via the Temperature Detection button and select the desired
temperature range.
•
Illumination: Changes in the brightness of a live image can trigger alarms. The camera's
image sensor performs illumination detection.
Open the shortcut menu via the Illumination Detection button and select the desired
trigger level.
For additional information, see the
section “ Events“ in the Software Manual .