User manual

31
© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • [e-mail]
31/144
Using MxEasy For The First Time
• Initialize Keypad:
–
Click on Train Keypad button.
– Enter the supervisor PIN on the Door Station
Keypad, train in the admin card and, if applicable,
severaluser cards (see T24 System Manual, Part
2, Section 2.2 “Setting Up The Keypad“).
– Click on the Keypad Trained button. The “Specify
Door Station Equipment“ window opens.
• Initialize BellRFID:
– Click on the Train BellRFID module button.
– Enter the supervisor PIN on the BellRFID mod
-
ule and set the bell button set (see BellRFI
D
QuickInstall, Installation and Initial Operation).
– Click on the BellRFID Trained button. The “Au-
tomatic Configuration” window opens once
m
ore. If needed, you can run the automatic
configuration again to correct any wrong entries.
Click on the Continue button. The “Specify Door
Station Equipment“ window opens.
Specify Door Station Equipment
The T24 system includes a fixed bell button on the camera module and – if it exists for
your system – one on the keypad. These two bell buttons have
the same function and were already integrated into the system
during the automatic configuration.
When using the BellRFID module, you set the desired bell buttons
at the module. When using the MX-232-IO-Box, two buttons are
displayed.
1.
Select the number of doorbells that will actually be used
without including the fixed bell button on the camera module
in the count (no display when using a BellRFID module or the
MX-232-IO-Box).
2. Activate the desired checkbox.
• Door position sensor and/or Lock position sensor:
Indicate which door sensors exist in the system and which terminal connectors are
relevant. This is important to receive correct status displays (door open/closed/
locked) in MxEasy.
If you do not know whether and where door sensors are connected, simply try out
the dierent options and check them using the the status display.
3. Click on the Continue button. The “Define Bells“ window opens.