User manual
© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
30/144
MxEasy User Manual: Installation And Initial Operation
If you have not yet conducted an automatic configuration,
then the “Select Integration with MxEasy“ window opens
with the following option fields (see image). In this case we
recommend Complete Integration.
1. Select the Complete Integration option.
2. Click on the Continue button. The “Configure Access
Mode“ window opens.
Configure Access Mode
1. Proceed as described in
Section 2.2.2 “Selecting And
Connecting New Cameras
.“ The “Change camera access“
window opens.
Change Camera Access
1. Proceed as described in
Section 2.2.2 “Selecting And Connecting New Cameras
.“
The door camera is reconfigured.
2. Click on the Continue button.
• If the automatic configuration was run before the camera was integrated, the
“Specify Door Station Equipment“ window opens (see further below).
• If the automatic configuration was not run, then the “Automatic Configuration“
window opens (see below).
• If a S15 FlexMount camera is integrated for
which the automatic configuration was not
yet run, then the „Configuration as Door Sta-
tion“ window opens. Click on
Yes. The S15 is
reconfigured and the „Automatic Configuration“
window opens.
Start Automatic Configuration
1.
Click on the Start Door Station Configuration button. The
system searches for existing Grandstream IP telephones
and other Door Station cameras. The Door Station modules
found are listed in a “Phone Device Selection“ overview.
(When no Door Station modules are found, a system mes-
sage opens. Then, click on the Continue button).
2.
Select the Door Station modules that should be integrated
into the system. Click on OK. This starts the automatic
configuration. This might take several minutes. Depending
on the connected bell module, either the “Initialize Keypad“
window or the „Initialize BellRFID“ window opens.