User manual

© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • [e-mail]
114/144
MxEasy User Manual: System Configuration
– Activate the checkbox Record Message if the visitor should have the option of
leaving a message.
5. If the message only profile was previously selected:
– Select a message that should be played to the visitor.
– Activate the checkbox Record Message if the visitor should have the option of
leaving a message.
6. Click on OK to confirm.
Changing Door Station Hardware
If changes occur in the hardware equipment of your Door Station, such as an upgrade
of the door sensors or bell buttons, then these changes must also be entered in MxEasy.
1. Select the “Equipment“ tab.
2.
Select the number of doorbells that will actually be used without including the fixed
bell button on the camera module and the bell button on an existing keypad in the
count.
3. Activate the desired checkbox.
– Door position sensor and door lock switch:
Indicate which door sensors exist in the system and which terminal connectors are
relevant. This is important to receive correct status displays (door open/closed/locked)
in MxEasy.
If you do not know whether and where door sensors are connected, simply try out
the dierent options and check them using the the status display.
– Automatic configuration enabled:
After successful initial operation and configuration of a T24 system, MOBOTIX recom-
mends preventing automatic reconfiguration by door camera to protect the system from
unwanted manipulation from outside. To do this, the checkbox must remain deactivated.
4. Click on OK to confirm.
4.6.2 Setting Up The Intercom Mode On Door Stations
For quality purposes, you can set dierent sound modes for two-way communication on
the Door Station. To do this, open the “Door Station“ tab via the Tools | Preferences menu.
1. Choose the desired mode:
– The standard setting is the “Hands-free talking“ mode. The sound settings cannot
be adjusted in this mode.
– In the “Headset“ and “Limited“ modes, you can adjust the sound settings.
To do this, open the “Audio“ tab via the Cameras | Camera Options menu. Enter
the settings that you want and then click on OK to confirm.