User manual

111
© MOBOTIX AG • Security Vision Systems • Made in Germany
www.mobotix.com • [e-mail]
111/144
Configuring MxAnalytics
• Activate the Backup existing recordings checkbox to secure recorded data. Otherwise
you will permanently lose the data!
• Device Usage: Select whether MxAnalytics recordings only (no
other recordings are stored) or all other recordings are to be stored
• MxAnalytics Volume Size: Approximately 1GB per month is
required to permanently store results data.
•
Enable Data Encryption: You can encrypt the recordings to ensure
the SD cards can be read only by entering the corresponding
password. To do this, activate the checkbox and select either
the automatically created encryption password (recommended)
or create your own password.
4.5.4 Controlling Motion Detection (Time Tables)– Optional
Video motion analysis can be permanently enabled or managed by a time table. If, for
example, you only want video motion analysis to be active during the opening hours of a
store, you must create a time table with the opening hours. Then, proceed to activate video
motion analysis and select the time table with these opening hours.
Hint: Limiting the analysis using a time table increases the accuracy of the results as objects
outside the analysis time frame are not captured or evaluated.
You can set up a suitable time table in the browser:
1. Open the Time Tables dialog in Admin> Camera Administration in the browser
interface of the camera. Define a suitable time table.
2. Next, select this time table in the “MxAnalytics” tab.
4.5.5 Customizing The Report Profiles Used For Analysis
You can call up the movement and heatmap evaluations as daily heatmap reports or
as weekly and monthly counting line reports. To do this, select heatmap/counting line
report profiles. There are several predefined profiles available, which you can adapt to
your requirements or you can define new profiles. To do this, open the “MxAnalytics” tab
via the Cameras| Camera Option dialog and click the Configure Counting Line Report
Profiles button or the Configure Heatmap Report Profiles button.
Configure Counting Line Report Profiles
1.
Click on Configure Counting Line Report Profiles. The
window to configure counting line report profiles opens.
2. Click on Add New Profile in the lower left corner to
define a new profile.
3. Enter a profile name and select the counting line to
be included in the evaluation.
4. Decide how many days the report should include.
To do this, click on the + button under unter Export
content and select the desired day in the selection
box. Repeat this step to select several days.