Specifications

99/1�61�6
Network And Power Connection
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
The MOBOTIX factory default is Class 2. This default is usually fine and nothing needs
to be changed. However, if the lower power level class 1 is sufficient for your application,
it may - due to possible internal power distribution schemes amongst the ports of the PoE
switch in use - be advantageous to change the PoE power level class in the browser:
Select 1. Admin Menu > Network Setup > Ethernet interface
(for experts).
Under Power Supply, click Change.2.
A 3. Power Wizard will appear to guide you through the PoE
configuration steps.
The camera will then need to be cycled through a hard reboot. 4.
Disconnect the camera from the power supply, then recon-
nect it, e.g. by disconnecting, then reconnecting the network
cable at a PoE switch.
Power Supply Using A Switch2.11.3
Connect the factory pre-installed cable of the 1.
camera to the Camera connector of the Network Power Adapter.
Connect the 2. LAN/Power connector of the NPA to an Ethernet connector of the
switch/router or the Ethernet wall outlet.
Plug the RJ45 connector of the external power unit into the 3. PC/Power connector
on the Network Power Adapter.
For the Q24M, you
should use the new
blue MX-NPA-PoE Set
- previous MOBOTIX
network power acces-
sories such as the NPA
Set, Power Box and
Power Rack (MX-NPA-
Set, MX-NPR-4 and
MX-NPR8/20) are
not suitable for use
with the Q24M
IP addresses in the
diagram are shown
only as an example