Specifications

96/1�61�6
Q24M Camera Manual: INSTALLATION
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
Replacing The MicroSD Card2.10
The camera must be taken down to remove, insert or replace a MicroSD card. To avoid
data loss, be sure to deactivate MicroSD card recording in the camera software and reboot
the MOBOTIX camera before removing the card.
Caution
A MicroSD card may only be removed from the camera after you have deactivated
Recording to SD Card and rebooted the camera. Failing to do so may lead to data
loss!
Removing The MicroSD Card2.10.1
Deactivate recording 1. : Recording to MicroSD card must be deactivated (Admin Menu >
Storage on External File Server / Flash Device). If MicroSD card recording is still
active, deactivate recording and reboot the camera. Section 3.4, Micro SD Card
Recording, contains more information on this topic.
Remove the outer shell2. : Remove all four Allen screws
using the supplied Allen wrench and lift off the outer
shell.
Remove the connection cables 3. : The connected cables
(patch cable, MiniUSB if present) must be removed from
the camera first by rotating and opening the bayonet
catch (see end of section 2.4.3).
4. Remove the back of the camera and take out the
MicroSD card: Remove the four screws from the back
plate using the supplied 2 mm Allen wrench and carefully
lift off the back plate. Gently push on the MicroSD card
in the card slot of the camera. The card will be released
from the slot and can then be removed from the cam-
era.
Bayonet catch open
Carefully loosen the rear
casing at the 4 openings
on the side with a screw-
driver before removing it
Push-push function: only
remove the MicroSD
card after rst gen-
tly pushing it in