Specifications

77/1�61�6
Mounting The Camera With The In-Ceiling Set
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
Ins e r t t h e c amera and the In-Ceiling Se t in to t h e ho l e7. : Make sure that all winged
cams are retracted before placing the In-Ceiling Set with the camera into the hole.
Pay attention to the orientation: the OBEN / TOP arrow should point in the direction
of the longer wall for ceiling installation in rectangular rooms. Tightening the
screws of the In-Ceiling Set extends the winged cams, thus firmly holding the set
in place.
8. Ins t all the de co rat i ve ri ng: Use the two wrenches from
the In-Ceiling Set to place the ring on the set as shown
in the figure and turn the ring clockwise until it stops.
The two wrenches from the In-Ceiling Set may also be
used for dismounting. Insert them as shown and turn the
ring counter-clockwise. Loosen the screws of the In-Ceiling
Set; this will automatically retract the winged cams. You
can now remove the In-Ceiling Set, with the camera still
attached, from the ceiling.
Clean the lens:9. If necessary, gently clean the front of the lens with a soft cotton
cloth. Do not apply excessive pressure to the surface of the glass when cleaning
the lens.
Establish a connection to the camera, check the image:10. Establish a connection
to the camera as described in sections 3.1 and above. The live image from the
camera should be visible on the computer monitor. Check image sections on the
computer monitor as well.
The blue winged cams
(see left) automatically
secure the In-Ceiling
Set in the ceiling when
tightening the screws
Installing the decorative
ring: turn clockwise
Removing the deco-
rative ring: turn
counter-clockwise - only
relevant when completely
removing the camera