Specifications

124/1�6
Q24M Camera Manual: OPERATING THE CAMERA
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
Special Q24M Conguration In The Browser3.3.2
Thanks to its hemispherical lens, the MOBOTIX Q24M provides certain special configuration
options for the image settings. Depending on where the camera is mounted (ceiling or
wall) and on the live image display preferred by the user, certain important basic settings
and, if necessary, their adjustment must be configured when a Q24M is first installed.
A corresponding adjustment of the image setting is strongly recommended if the on-wall
set is mounted with an inclination of 10 degrees (available as a Q24M accessory).
To congure the Q24M basic settings in the browser (without installing the software),
carry out the steps described on the following pages:
Log the camera on and boot it1. as described in section 3.2.
Select mounting position wall/ceiling2. : Click "Installation" in the Quick Control
panel and then select "Wall" or "Ceiling according to the position of the camera.
"Ceiling" always means that the camera points from top to bottom, so this is
also the case for a lowered mounting on an extension attached to the wall (see
section 1.1).
Important3. : After the camera has been installed, the "Installation" opti on ca n o nly
be selected if the "Display Mode" was set to "Normal" beforehand.
The result is a 4. corrected default view. This serves as the basis for carrying out
all vPTZ commands.
Then switch to the Quick Control 5. "Display Mode".
Set the mode that you want to be the standard view. For demonstration purposes, 6.
the descriptions below describe the typical display mode for the wall mount and
the ceiling mount, "Panorama" and "Surround" respectively. Every other dis-
play mode can be operated in the same way (see section 3.3.3, Overview of the
Available Camera Views).