Manual
Table Of Contents
- Added Security Value
- Cost Benefits And Technical Advantages
- 2 INSTALLATION
- 3 OPERATING THE CAMERA
- 3.1 Manual And Automatic Operation - Overview
- 3.2 First Images And The Most Important Settings
- 3.3 Virtual PTZ
- 3.4 Correction Of Lens Distortion (L22 Only)
- 3.8 Additional Notes
- 3.8.1 Weatherproof Qualities
- 3.8.2 Password For The Administration Menu
- 3.8.3 Starting The Camera With The Factory IP Address
- 3.8.4 Reset The Camera To Factory Settings
- 3.8.5 Activate Event Control And Motion Detection
- 3.8.6 Deactivate Text And Logo Options
- 3.8.7 Deactivating The Daily Automatic Camera Reboot
- 3.8.8 Browser
- 3.8.9 Cleaning The Camera And Lens
- 3.8.10 Safety Warnings
www.mobotix.com • sales@mobotix.com
The camera must be taken down to remove, insert or replace a MicroSD card. To avoid
data loss, be sure to deactivate MicroSD card recording in the camera software and reboot
the MOBOTIX camera before removing the card.
Caution
A MicroSD card may only be removed from the camera after you have deactivated
recording to a Flash device and rebooted the camera. Failing to do so may lead to
data loss! Before inserting the MicroSD card, make sure that it is not write-protected!
•
: Recording to MicroSD card must be deactivated (
Admin Menu>
). If MicroSD card recording is still
active, deactivate recording and reboot the camera. Section 3.4, Micro SD Card
Recording, contains more information on this topic.
•
: Remove all four Allen screws using
the supplied Allen wrench and lift o the outer shell.
•
. Use the supplied plas-
tic foil or a lint-free cotton cloth to remove the dome by
turning it in a counter-clockwise direction.
•
: Gently push on the MicroSD
card in the card slot of the camera. The card will be released
from the slot and can then be removed from the camera.
Push-push function: only
remove the MicroSD
card after rst gen-
tly pushing it in