Manual
Table Of Contents
- Added Security Value
- Cost Benefits And Technical Advantages
- 2 INSTALLATION
- 3 OPERATING THE CAMERA
- 3.1 Manual And Automatic Operation - Overview
- 3.2 First Images And The Most Important Settings
- 3.3 Virtual PTZ
- 3.4 Correction Of Lens Distortion (L22 Only)
- 3.8 Additional Notes
- 3.8.1 Weatherproof Qualities
- 3.8.2 Password For The Administration Menu
- 3.8.3 Starting The Camera With The Factory IP Address
- 3.8.4 Reset The Camera To Factory Settings
- 3.8.5 Activate Event Control And Motion Detection
- 3.8.6 Deactivate Text And Logo Options
- 3.8.7 Deactivating The Daily Automatic Camera Reboot
- 3.8.8 Browser
- 3.8.9 Cleaning The Camera And Lens
- 3.8.10 Safety Warnings
www.mobotix.com • sales@mobotix.com
Use the supplied screw anchors, screws and washers to ax the Corner and Pole Mount
to a building corner.
• Mark the on the corner of the
building, ensuring that the arrows on the mount point
upwards. Drill the holes with a 10 mm wall drill.
•
Pass the on-site network cable through one of the large
round holes at the back of the Corner and Pole Mount,
then through one of the 16mm diameter holes on the
front of the mount. In order to properly protect the cabling,
you should let the cabling run from the inside of the
building through the Corner and Pole Mount directly
into the camera (concealed cabling).
• Place the included in the drilled holes
and screw the Corner and Pole Mount into place on
the corner of the building using the Torx screws and
washers. Use the supplied drilling template (fold-out
at the end of this manual) to mark the exact positions
for the drill holes.