Manual
Table Of Contents
- Added Security Value
- Cost Benefits And Technical Advantages
- 2 INSTALLATION
- 3 OPERATING THE CAMERA
- 3.1 Manual And Automatic Operation - Overview
- 3.2 First Images And The Most Important Settings
- 3.3 Virtual PTZ
- 3.4 Correction Of Lens Distortion (L22 Only)
- 3.8 Additional Notes
- 3.8.1 Weatherproof Qualities
- 3.8.2 Password For The Administration Menu
- 3.8.3 Starting The Camera With The Factory IP Address
- 3.8.4 Reset The Camera To Factory Settings
- 3.8.5 Activate Event Control And Motion Detection
- 3.8.6 Deactivate Text And Logo Options
- 3.8.7 Deactivating The Daily Automatic Camera Reboot
- 3.8.8 Browser
- 3.8.9 Cleaning The Camera And Lens
- 3.8.10 Safety Warnings
www.mobotix.com • sales@mobotix.com
The Wall Mount allows you to easily mount D24M cameras to walls or extensions, both
The Wall Mount allows you to easily mount D24M cameras to walls or extensions, both
indoors or outdoors. The camera remains IP65 weatherproof (dust-proof and resistant
indoors or outdoors. The camera remains IP65 weatherproof (dust-proof and resistant
to water jets). The Wall Mount also covers RJ45 flush-mounted sockets and has ample
to water jets). The Wall Mount also covers RJ45 flush-mounted sockets and has ample
space for additional modules (Mx2wire, WLAN, batteries, etc.).
space for additional modules (Mx2wire, WLAN, batteries, etc.).
the MOBOTIX D24M with the Wall Mount, you must prepare the network
the MOBOTIX D24M with the Wall Mount, you must prepare the network
connection and drill the holes for the fixtures:
connection and drill the holes for the fixtures:
•
The
is passed through the opening
in the back of the Wall Mount. The cable and the required
in the back of the Wall Mount. The cable and the required
(standard) connector for the camera cable (patch cable) are
(standard) connector for the camera cable (patch cable) are
ideally protected by a robust wall sealing made from foam
rubber. Nothing is visible or accessible from the outside. The
Wall Mount may be mounted directly on top of surface- or
flush-mounted sockets. Maximum width x height of the
socket: 88 mm x 80 mm.
•
Only
use the
of the D24M (50 cm cable length) or a
MOBOTIX cable that is available as an accessory in various lengths.
•
All
openings of the camera housing need to be properly sealed. This is the only way
to guarantee that the camera remains weatherproof.
•
The
supplied screw anchors should be used for the
in the wall. Use the
drilling template for the D24M Wall Mount (fold-out at the end of this manual) to
mark the exact position for the drill holes and the holes through which the cables
will later be fed.
Direct installation over
surface- and ush-
mounted sockets