Manual




www.mobotix.com • [e-mail]
7. : Make sure that all winged
cams are retracted before placing the In-Ceiling Set with the camera into the hole.
Tightening the screws of the In-Ceiling Set extends the winged cams, thus firmly
holding the set in place.
8. : Use the two wrenches from
the In-Ceiling Set to place the ring on the set as shown
in the figure and turn the ring clockwise until it stops.
The two wrenches from the  are also used
for . Insert them as shown and turn the ring
counter-clockwise. Loosen the screws of the In-Ceiling
Set; this will automatically retract the winged cams. You
can now remove the In-Ceiling Set, with the camera still
attached, from the ceiling.
9. Proceed to Section 2.11, Aiming And Adjusting The Lens.
The blue winged cams
(see left) automatically
secure the In-Ceiling
Set in the ceiling when
tightening the screws
Removing the decora-
tive ring:
turn counter-clockwise
– only relevant when
completely remov-
ing the camera
Installing the decora-
tive ring:
turn clockwise