Manual
Table Of Contents
- Added Security Value
- Cost Benefits And Technical Advantages
- 2 INSTALLATION
- 3 OPERATING THE CAMERA
- 3.1 Manual And Automatic Operation - Overview
- 3.2 First Images And The Most Important Settings
- 3.3 Virtual PTZ
- 3.4 Correction Of Lens Distortion (L22 Only)
- 3.8 Additional Notes
- 3.8.1 Weatherproof Qualities
- 3.8.2 Password For The Administration Menu
- 3.8.3 Starting The Camera With The Factory IP Address
- 3.8.4 Reset The Camera To Factory Settings
- 3.8.5 Activate Event Control And Motion Detection
- 3.8.6 Deactivate Text And Logo Options
- 3.8.7 Deactivating The Daily Automatic Camera Reboot
- 3.8.8 Browser
- 3.8.9 Cleaning The Camera And Lens
- 3.8.10 Safety Warnings
www.mobotix.com • sales@mobotix.com
6.
: Separate the black mount-
ing ring from the camera housing (lift the spring clip).
This ring is not required when mounting the camera to
the On-Wall Set.
7.
: Connect the on-site network cable
to the network cable passing through the On-Wall Set
using a standard connector. Make sure to leave enough
unused cable inside the housing. This will ensure that
you can turn and tilt the lens mount freely later on. Excess
cable can be easily stored within the On-Wall Mount.
8.
: Press the D24M so that
it is seated firmly within the On-Wall Mount. The tapered
guides at the back of the D24M housing fit exactly into
the openings of the On-Wall Mount. Attach the white
outer shell with the supplied Allen screws (without rubber
seal) once the lens has been adjusted.
9.
Proceed to S ection 2.11, Ai ming A nd Adjus t ing T he Lens.