Manual
Table Of Contents
- Added Security Value
- Cost Benefits And Technical Advantages
- 2 INSTALLATION
- 3 OPERATING THE CAMERA
- 3.1 Manual And Automatic Operation - Overview
- 3.2 First Images And The Most Important Settings
- 3.3 Virtual PTZ
- 3.4 Correction Of Lens Distortion (L22 Only)
- 3.8 Additional Notes
- 3.8.1 Weatherproof Qualities
- 3.8.2 Password For The Administration Menu
- 3.8.3 Starting The Camera With The Factory IP Address
- 3.8.4 Reset The Camera To Factory Settings
- 3.8.5 Activate Event Control And Motion Detection
- 3.8.6 Deactivate Text And Logo Options
- 3.8.7 Deactivating The Daily Automatic Camera Reboot
- 3.8.8 Browser
- 3.8.9 Cleaning The Camera And Lens
- 3.8.10 Safety Warnings
www.mobotix.com • sales@mobotix.com
Mx2wire Media Converter (MX-2wire-Set-PW)
The Mx2wire system allows you to set up an Ethernet
network with PoE via two-wire telephone cables of up to
500 m in length. This allows an existing two-wire ana-
log telephone line to be used to connect a 10/100 Mbps
Ethernet device (e.g. PC, WLAN, IP camera, IP telephone
or IP door station). The achievable data rate is up to 30
Mbps. Around 15 Mbps can be reached even with 500
m
of antenna cable.
An identical Mx2wire device is placed at the beginning and
the end of the line. Configuration as sender or receiver is
automatic. The Mx2wire units are supplied with power via
PoE by the feeding network cable. The connected devices
are supplied with up to 7 watt over PoE, as the injected
PoE signal is transmitted parallel to the network signal.
Mx2wire is delivered in the standard wall outlet frame
available in dierent designs, however, it can also be used
with the on-wall outlet that is included.
Mx2wire
Mx2wire
Data and
power