Specifications

65/136
Mounting the Camera with Wall Mount
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
Procedure
1. Install and prepare the network connection: The
pre-installed camera patch cable must be con
-
nected with the on-site network cable. The con-
nection can either be established using an installed
flush-mounted socket with RJ45 connector or – in
the case of a protruding network or patch cable –
using the MX-Overvoltage-Protection-Box. In both
cases, the connection is well protected and is neither
accessible nor visible from the outside.
2. Drill the holes: Use the supplied drilling tem
-
plate for the camera (found at the end of the
manual). Drill the holes for the supplied screw
anchors. Screw anchors do not have to be fitted
if the surface is made of wood. To secure the
mount, the supplied stainless steel hex head
screws will later be screwed directly into the
surface. In order to facilitate screwing in wood,
the positions should first be predrilled using a
2mm drill bit, for example (drilling depth just
slightly less than screw length).
3. Attach wall seal: Place the white rubber seal with
the groove on the edge of the wall mount.
4. Connect the cable: Connect the on-site network
cable to the camera patch cable using an adapter
or insert the patch cable into the RJ45 outlet. When
using an MX-Overvoltage-Protection-Box, follow the
installation instructions supplied with the product.
You can download the PDF file from the MOBOTIX
website www.mobotix.com in the Support >
Manuals section. Make sure that the cables are
not bent or squashed.
Interface box
M25M Wall Mount
No screw anchors
are required in
wooden surfaces
Additional seal possible
(e.g., heat shrink tube)