Specifications

89/146
Network And Power Connection
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
2.9.6 Camera Startup Sequence
As soon as the camera's power supply has been established, the two LEDs will show the
progress of the startup sequence (see Section5.4.3 LED Signals and LED Configuration in
the MOBOTIX Camera Software Manual Part 2 ).
• Booting: Immediately after connecting the power supply, the red LED lights up, blinks
for two seconds, then stays on permanently red. A camera self-test is carried out at
this point, and the entire system is started. In case of an error, the camera will start
using the backup system.
• Waiting for key pressed: Both LEDs light up for four seconds. If you press the R or
L key of the camera during this time, the camera will execute the corresponding
function (see Sections 3.2.5 and 3.2.6 Starting the Camera with IP Address ).
• Ready: Once the camera software has been started, the green LED is on permanently
and the red LED blinks. You can now connect to the camera via the network using a
browser.
Notes
During the startup sequence of the camera, the LEDs will always light up, even if they
have been deactivated in Admin Menu> LED Setup.
1. Start
2. Key?
3. Ready
LEDs
R key L key