Manual

M16 Camera Manual: Installation

6. Mount the camera: Place the wall mount over the

predrilled positions in the pole mount and tighten it

using the supplied M6x25 mm screws (item 1.2), washers

(item 1.4) and M6 hex nuts (item 1.5). Place the white

caps on the screw heads. Then aim the camera as

described in Section 3.3.

7. Clean sensor modules: Clean the protective glass

and the dome of the sensor modules with a clean

socottonclothforoptimalimageresults.

8. Establish a connection to the camera, check the

image:

Establish a connection to the camera as described in Section 3.1, «Manual

and Automatic Operation – Overview» and the following sections. The live image from

the camera should be visible on the computer monitor. Check image sections on the

computer monitor.

Note

The

VarioFlex mount

and

wall mount

must always be used for

pole installation

. The

VarioFlex ceiling mount should not be used.

Screw caps for lock screws