Manual

67
Mounting the Camera with Pole Mount (Accessories)
Procedure
1. Prepare the cable: Guide the on-site network cable
from behind through the middle opening of the pole
mount. Ideally, the cable should be guided directly
from the pole into the cavity socket of the VarioFlex
wall mount, where it is connected with the camera
patch cable (concealed cabling) via an adapter (such
as MX-Patch-Box).
2. Prepare the straps: Guide the two stainless steel straps
through the pole mount. The pole must have a diameter
between 60 mm and 180 mm.
3. Attach pole mount: Place the straps around the pole
and tighten them using a screwdriver. If necessary, the
endsofthestrapscanbecuto.
4. Attach rubber sealing ring: Place the white rubber seal-
ing ring with the groove on the edge of the wall mount.
5. Connect the cable: Connect the on-site network
cable to the camera patch cable using an adapter
or insert the patch cable into the RJ45 outlet. Take
note of the installation manual included in the pack-
age when using a MX-Patch-Box. All manuals can be
downloadedandprinted(asPDFles)fromtheMOBOTIX
website (www.mobotix.com) in the Support >
Download Center > Documentation > Manuals sec-
tion. Make sure that the cables are not bent or squashed.