Manual
58
M16 Camera Manual: Installation
Procedure
1. Install and prepare the network connection: The
pre-installed patch cable attached to the camera
must be connected with the on-site network cable.
The connection can either be established using an
installed in-wall socket with RJ45 connector or, in
the case of a protruding network or patch cable,
using the MX-Patch-Box. In both cases, the connec-
tion is well protected and is neither accessible nor
visible from the outside.
2.
Drill the holes: Use the drilling template for the
camera (available on www.mobotix.com >
DownloadCenter>Documentation>Manuals
or, if used, the extended drilling template
included in the MX-Patch-Box package). Drill the
holes for the supplied screw anchors. Screw
anchorsdonothavetobettedifthesurface
is made of wood. To secure the mount, the sup-
plied stainless steel hex head screws will be
screwed directly into the surface later on. You
should start with a 2-mm drill bit, for example
(drilling depth just slightly less than screw
length), in order to facilitate screwing in wood.
3. Attach wall seal: Place the white rubber sealing
ring with the groove on the edge of the wall mount.
4. Connect the cable: Connect the on-site network
cable to the camera patch cable using an adapter
or insert the patch cable into the RJ45 outlet. Take
note of the installation manual included in the pack-
age when using a MX-Patch-Box. All manuals can
bedownloadedandprinted(asPDFles)fromthe
MOBOTIX website (www.mobotix.com) in the
Support > Download Center > Documentation >
Manuals section. Make sure that the cables are not
bent or squashed.
MX
30.876
Interface Box
M16WallMount
No screw anchors
are required for
wooden surfaces
Additional sealing pos-
sible, for example,
with shrink tubing