Manual

50
M16 Camera Manual: Installation
6. Connect the sensor module cable to the sensor
module
: Guide the cable through the opening in the
frontelement and rmly push the sensor module
cable into the connector. Apply bayonet catch as
shown and turn it clockwise until it gently snaps shut.
7. Insert the sensor module: Make sure that the
MOBOTIX lettering on the sensor module is at the “9
o’clock”positionasshowninthegure.Usingthe
black module wrench, turn the sensor module clock-
wise until it stops.
8. Insert the security clips: To protect the modules
against unwanted rotation insert the two red security
clips at the insides of the sensor modules (as shown
inthegure).Makesurethatthesecurityclipsclick
into place as shown in the image detail.
9. Close camera housing: Close the camera housing
as described in Section 2.2.8.
2.2.5 ReplacingtheEthernetPatchCable
If you want to replace the pre-installed MOBOTIX patch cable (0.5 m/20 in) by a longer one,
make sure that you only use genuine MOBOTIX cables (see Section 1.5.5, «Ethernet Patch
Cable for Bayonet Catch»).
Procedure
1. Open camera housing: Open the camera housing
as described in Section 2.2.2.
2. Remove the patch cable : Turn the bayonet catch of
the patch cable at the inner housing cover (red circle
ingure)counter-clockwiseandremovethecatch.
M
O
B
O
T
I
X