Manual

46
M16 Camera Manual: Installation
Procedure
1. Prepare the sensor module : Remove the plastic
lock nut (this is not needed any more). Remove the
bayonet catch by rotating it counter-clockwise, then
remove the blue rubber plug.
2. Remove the transport plugs : Gently pull the two
transport plugs out of the sensor module sockets by
liingtherimoftheplugs.Nowpulltheconnectors
of the sensor module cables out of the back of the
transport plugs; take care not to damage the con-
nectors or the cables.
Make sure that you do not
pull the sensor module cables out of the housing!
3. Connect sensor module cable : Firmly push the
sensormodulecableintothemodule’s connector
asshowninthegure.
4. Lock sensor module cable : Apply bayonet catch as
shown and turn it clockwise until it gently snaps shut.
5. Insert the sensor module : Make sure that the
MOBOTIX lettering on the sensor module is at the “9
o’clock”positionasshowninthegure.
M
O
B
O
T
I
X