Manual

105
Virtual PTZ and Full Image Recording
SensorConguration(OnlywithTwoSensorModules)
Sensorcongurationspecieswhichsensormoduleisconnectedtowhichofthecamera’s
connections (Cam1 or Cam2),andinwhichcameraimage(le/right)thesensormoduleis
to appear for the dual image display. Open the corresponding dialog box here: Admin Menu >
Sensor Conguration.
You should also open the Sensor Conguration dialog box in the following cases:
• Swapping the displayed camera images :Youwishtodisplaythelecameraimage
on the right (and vice versa) without having to replug the sensor module cables on
the camera itself.
• Replacement of sensor modules :Inthiscase,theM16detectsaerstartupthatthe
sensor modules have been replaced and indicates this through an alert superimposed on
the live image as well as through a system message (Admin Menu > System Messages;
seeSection3.4.3,«SpecialM16CongurationintheBrowser».
• Adding/switching on sensor modules: This is where you can re-enable deactivated
modules.
• Removing/switching o sensor modules : This is where you can deactivate any con-
nected modules if needed.