Datasheet

88/148
T24 System Manual Part 1: Installation
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
2.4.3 Installing The Info Module T24-Info
The info field in the info module of the T24 door station without Mx2wire+ technology is
equipped with permanent LED backlighting supplied via MxBus.
1. Ensure that the seal is fitted to the info module.
2.
Loosen the rear cover plate (using a small screwdriver
or similar tool) and remove it. You now have a clear
view of the connectors located directly on the info
module board.
3.
Remove approximately 5 mm of insulation from each
of the cables to be connected and feed each cable
through one of the wire apertures in the housing
(piercing the rubber membrane with the cable).
Seal