Datasheet

121/148
Finishing The Installation
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
Checking The Wiring
Activating Anti-Theft Protection
Test the anti-theft protection module by pressing and holding down
the two buttons on the T24-DoorMaster until the blue LED blinks.
This deactivates the anti-theft protection in the frame for 90 seconds
(see Section 2.4.6).
Use the special key to release the module above the mechanical
anti-theft protection lock and turn the red button to the ‘closed
lock’ symbol (see Section 2.3.7). Insert all the modules securely
back into the frame. The modules can only be removed now after
deactivating the anti-theft protection.
Before operating the door station, the batteries in the T24-DoorMaster must be fully charged
(maximum charging time: 12 hours). Finish the installation with Section 2.8.2. that follows.
8$2+ 2$V3$'1$ (#") +">
+" /"++")j 3'*7*&<*/<$
)";3<$2 *#$ 26&>>$;
Check LED on T24-Info2wire+ info module/indoor unit
Info module: Green and orange LEDs light up
Indoor unit: Green LED flashes, orange LED lights up
Check camera lights T24-CamCore
Buttons and light strips light up after boot phase
Check LED signal on T24-DoorMaster
Blue and green LEDs flash
Check connection of door sensors
Close and lock door: Blue LED of the T24-DoorMaster
lights up, green LED flashes
Check LED signal on T24-KeypadRFID
Blue and green LEDs flash
Check lights on T24-Info info module
LEDs on the info module light up
S5$' * /*++$#4 &2
*<)"2+ 1")><$+$<4
;&215*#@$;A +5$ #$; d`C
"' +5$ 89:?C""#!*2+$#
<&@5+2 3> ]#2+ P("#
*>>#"0 )*+$<4 Ec )&'.Q