Datasheet

112/148

T24 System Manual Part 1: Installation

www.mobotix.com • sales@mobotix.com

4. Screw the two-wire cable to terminals 1 and 2: The

cable does not necessarily need to be attached to the

terminal with the same number on both T24-Info2wire+

units. The device continues to function if connectors 1

and 2 are swapped.

Connectors 3 and 4 are only assigned if an external

voltage source (48 V DC) is used.

Insert the housing and circuit board into the surface-

mounted socket: The two cable clamps on the rear

of the housing are located at the top. Attach the

housing and board to the surface-mounted socket

by fastening the four stainless steel screws in the

four existing drill holes.

Attach the frame: Place the selected frame (concave,

convex or ﬂat) onto the board and press down gently

until it automatically snaps into place. MOBOTIX is

printed on the bottom of the frame.

Insert the panel: Hook the front panel onto the frame,

as shown in the ﬁgure, and then press it down.

8. Screw the panel on tightly: Secure the front panel

using the panel's stainless steel screw.

85$ ;$7&1$ 1"'+&'3$2 +"

(3'1+&"' &( 1"''$1+"#2

E *'; 9 *#$ 2-*>>$;

4 3 2 1

First hook panel on underneath,

then press down the top