Datasheet

111/148
Installing The Indoor Unit T24-Info2wire+
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
2.6.4 Installation With Surface-Mounted Socket
1. Prepare the surface-mounted socket: Preparation:
Please refer to the figure on the right and use the
surface-mounted socket as a template to mark the
drill holes. Make sure that the alignment and position
of the socket in relation to the two-wire cable are correct
(TOP/OBEN arrows).
2.
Feed in the two-wire cable (plus optionally the 48 V
connector) and screw on the surface-mounted
socket: Feed the two-wire cable through the opening
provided that is sealed with a rubber plug. Use the
8-wire plug for multi-wire cables. You only require
two of these wires for T24-Info2wire+. The other two
plugs with only one opening are ideally suited to
insulated, two-wire cables of varying thickness. Now
use the four Torx screws to securely fasten the surface-
mounted socket to the screw anchors or directly to
the (wooden) surface. Please ensure that you only
use the existing four drill holes of the surface-mounted
socket.
3.
Remove the front panel and frame: In order to protect
the circuit board, the board is attached to the front
panel and frame in the original packaging. To continue
with the installation, however, you must first separate
the board and housing from the panel and frame.
Loosen the screw in the front panel and lift the panel
forwards.
Now remove the attached frame from the circuit board.
Please note that you will need the stainless steel
screw in the front panel again later.
60 mm
40 mm
D3>>< $; #3//$# ><3@ ("#
2$*<&'@ +5$ +-"?-&#$ 1*/<$,
="# 1*/<$2 -&+5 * Iec )) g
="# 1*/<$2 -&+5 * ceX )) g
="# 1*/<$2 -&+5 * )*0&)3)
"( $&@5+ - #$2
85$ 21#$- ;"$2 '"+ '$$;
+" /$ #$)"7$; 1")><$+$<4
(#") +5$ (#"'+ >*'$<