User manual

3.2 Sensors and Input/Output Interfaces of the ExtIO
The ExtIO has the following sensors and input/output interfaces:
• Status LEDs
• Speaker and Microphone
• Buttons (L – “Lights”, R – “Bell”)
• PIR Motion Sensor
• Signal Inputs/Outputs
• Temperature sensor
The following sections contain an overview over the additional configuration op-
tions if an ExtIO has been attached and connected.
3.2.1 Status LEDs
In addition to the camera LEDs, you can now also configure the ExtIO's LEDs (Admin
Menu> LED Setup).
3.2.2 Speaker and Microphone
Once the ExtIO has been attached and is connected, it will automatically activate its
microphone and speaker and deactivate the microphone and speaker of the MO-
BOTIX camera.
All events, actions or messages that are involving the speaker or the microphone
will not use the camera's speaker and microphone, but the speaker and micro-
phone of the ExtIO.
To configure the speaker and microphone, open Admin Menu > Loudspeaker
and Microphone. This dialog also contains options for activating an external mi-
crophone connected to Line In (via a pre-amplifier) and an external speaker con-
nected to Line Out (via an amplifier).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
62/76
MOBOTIX ExtIO User Manual