User manual

2.7 Mounting the ExtIO
2.7.1 Mounting the ExtIO Without Additional Mounting Options
1) Prepare the network or USB connection: The network cabling or USB cable
need to enter the ExtIO from the back in the center of the housing. The ca-
bling is perfectly protected by the mount and cannot be seen or damaged.
2) Prepare the holes and the wall outlet: Drill
the holes for the supplied dowels (item1.11).
We also recommend using a flush-mounted
wall outlet.
Use the supplied drilling template for the
mounting ring (fold-out at the end of this
manual) to mark the position for drilling the
dowel holes and the hole for the wall outlet.
3) Attach the mounting ring to the wall or ceil-
ing: Attach the mounting ring of the ExtIO to
the designated position at the wall or ceiling
using the delivered screws (item1.12), the
washers (item1.13) and the Torx wrench
(item1.15).
4) Prepare ExtIO with cables: Connect the Eth-
ernet or USB cable and all other required ca-
bles to the ExtIO and reassemble the ExtIO
again. Make sure that the housing is properly
closed and that it is sealed off using the ap-
propriate rubber plugs. For more information
on this topic, see section2.6,
Connecting the
Cables to the ExtIO
.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
48/76
MOBOTIX ExtIO User Manual
Find the folded drilling
template for the mounting
ring of the ExtIO at the
end of the manual!
The red circle marks up
the hole to cut for the
wall outlet
Maximum torque for all
screws is 1 to 1.2Nm
(0.74lbf ft)
Note
Use a flush-mounted (empty) wall outlet for the cabling. The ExtIO itself
cannot be mounted directly on top of protruding wall outlets.
Drill the holes
Attach the mounting ring to the wall
Prepare ExtIO with cables