User manual

5) Prepare the cable ties: Push one of the cable
ties supplied with the ExtIO from the top
downwards into the plastic clamp prepared
for this purpose.
6) Lock the cable in place with cable tie: Lock
all wires of the cable in place using the cable
tie and clip the superfluous end of the cable
tie.
7) Lock the wires in the terminal connector:
Shorten the individual wires to the required
length. Remove about 5mm (3/16in) from
the wire's insulation, guide it into the appro-
priate cable connector and tighten the screw.
Please also read the notes in sections 2.4.3,
ExtIO Terminal Connector1 (Signal Inputs/Out-
puts)
and 2.4.4, ExtIO Terminal Connector2
(Line-In/Line-Out)
.
8) Reseat ExtIO housing into the back and
tighten the screws: Close the ExtIO housing
again by reseating the ExtIO's top into the
back. To do so, properly align the two arrows
at the rims of the top and the back.
The back of the ExtIO also has a mark for the
speaker. This mark shows the proper position
of the two housing parts towards one an-
other.
Make absolutely sure that top of housing is
properly seated in the back all around the housing (firmly press the top into
the back). This will guarantee the weatherproofness (IP65) of the ExtIO.
Fas-
ten the ExtIO's back using the two Fillister head screws in the corresponding
holes.
Use a suitable Phillips screwdriver for this task. Finally make sure that
all rubber plugs in the ExtIO's back are firmly in place and that they seal off
the housing properly.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
47/76
MOBOTIX ExtIO User Manual
Mark for speaker inside
the back
Maximum torque for all
screws is 1 to 1.2Nm
(0.74lbf ft)
Prepare the cable ties
Lock the cable in place with cable
tie and clip cable tie
Lock the wires in the terminal con-
nectors
Assemble ExtIO housing
Align arrows