User manual

2.6.3 Connecting Additional Components to the ExtIO
1) Remove the outer shell from the ExtIO: Re-
move the outer shell (item1.3) from the ExtIO.
Use the supplied Allen wrench (item1.14) for
this purpose.
2) Remove the mounting ring from the ExtIO:
Remove the mounting ring from the ExtIO.
Carefully bend the four black clamps of the
mounting ring back using a suitable tool, one
after the other. While doing so, press against
the housing from below to push the housing
out of the clamps.
3) Remove the back of the ExtIO housing: Re-
move the back of the ExtIO. Use a suitable
Phillips screwdriver to remove the two Fillister
head screws in the bottom. Gently press on
the screw heads with the screwdriver before
fully removing them; this will press the top
shell of the housing out of its seat. Never in-
sert tools into the sealed openings as this
may damage parts on the ExtIO's main
board!
4) Prepare the wires and the ExtIO's back:
Push each of the wires through one of the
openings of the 8-wire rubber plug in the
ExtIO's back (item1.6). Use one of the two
rubber plugs at the top for this purpose (see
figure). The rubber plug at the center should
remain closed for the Ethernet or the USB ca-
ble.
Make sure that the openings in the ExtIO's
back are properly sealed off later on with the
8-wire rubber plugs.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
46/76
MOBOTIX ExtIO User Manual
Use 8-wire rubber plug
Remove outer shell
Remove mounting ring
Remove the back of the housing
Push each wire through one of the
openings of the 8-wire plug