User manual

5) Close off ExtIO's back with USB plug: Care-
fully close off the opening in the ExtIO's back
using the integrated plug of the Ethernet ca-
ble. Make sure that about 17cm/6.7in of free
cable remain in the camera. All MOBOTIX
USB cables have been prepared in such a
way.
6) Connect USB cable to Mini USB connector
of the ExtIO and guide the cable in the
housing: Insert the plug of the Mini USB con-
nector of the MOBOTIX USB cable into the
proper connector of the ExtIO.
Before closing the ExtIO housing, make sure
that the USB cable runs properly beneath the
speaker (see figure).
7) Reseat ExtIO housing into the back and
tighten the screws: Close the ExtIO housing
again by reseating the ExtIO's top into the
back. To do so, properly align the two arrows
at the rims of the top and the back.
The back of the ExtIO also has a mark for the
speaker. This mark shows the proper position
of the two housing parts towards one an-
other.
Make absolutely sure that top of housing is
properly seated in the back all around the housing (firmly press the top into
the back). This will guarantee the weatherproofness (IP65) of the ExtIO. Fas-
ten the ExtIO's back using the two Fillister head screws in the corresponding
holes. Use a suitable Phillips screwdriver for this task. Finally make sure that
all rubber plugs in the ExtIO's back are firmly in place and that they seal off
the housing properly.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
45/76
MOBOTIX ExtIO User Manual
Mark for speaker inside
the back
Maximum torque for all
screws is 1 to 1.2Nm
(0.74lbf ft)
Close off opening with rubber plug
Insert USB plug
Properly guide the cable
Assemble ExtIO housing
Align arrows