User manual

2.6.2 Connecting the USB Cable to the ExtIO
1) Remove the outer shell from the ExtIO: Re-
move the outer shell (item1.3) from the ExtIO.
Use the supplied Allen wrench (item1.14) for
this purpose.
2) Remove the mounting ring from the ExtIO:
Remove the mounting ring from the ExtIO.
Carefully bend the four black clamps of the
mounting ring back using a suitable tool, one
after the other. While doing so, press against
the housing from below to push the housing
out of the clamps.
3) Remove the back of the ExtIO housing: Re-
move the back of the ExtIO. Use a suitable
Phillips screwdriver to remove the two Fillister
head screws in the bottom. Gently press on
the screw heads with the screwdriver before
fully removing them; this will press the top
shell of the housing out of its seat. Never in-
sert tools into the sealed openings as this
may damage parts on the ExtIO's main
board!
4) Guide the USB cable through the ExtIO's
back: Remove the rubber plug at the center
of the ExtIO's back. This plug will not be used
any more in the course of the installation
process. Guide the model-specific USB cable
with the angled Mini USB plug through the
opening into the interior.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
44/76
MOBOTIX ExtIO User Manual
MOBOTIX USB cables:
M12/D12:
SUB HD to Mini USB
MX-CBL-HD-MU-5
(5 m/16 ft)
M22M:
USB to Mini USB
MX-CBL-U-MU-5
(5 m/16 ft)
D22M:
Mini-USB to Mini-USB
MX-CBL-MU-MU-1
(1 m/3 ft)
MX-CBL-MU-MU-5
(5 m/16 ft)
Remove outer shell
Remove mounting ring
Remove the back of the housing
Remove center plug and
guide USB cable through