User manual

5) Guide the Ethernet cable through the
ExtIO's back and close the opening with a
plug: Remove the rubber plug at the center of
the ExtIO's back. This plug will not be used
any more in the course of the installation
process. Guide the Ethernet cable through the
opening into the interior. Make sure that
about 17cm/6.7in of free cable remain in the
camera. Carefully close off the opening in the
ExtIO's back using the integrated plug of the
Ethernet cable.
6) Lock Ethernet cable in place with clamp:
Lock the Ethernet cable in place using the left
clamp. When tightening the clamp with a
suitable Phillips screwdriver, make sure that
the clamp holds down the folded-back
sheath of the Ethernet cable.
7) Insert the cable wires using the LSA PLUS
tool: Insert the cable wires using the LSA
PLUS wire insertion tool: Make absolutely
sure that you insert the wires according to
their colors as shown. Please also observe
the notes in section 2.4.2,
ExtIO Terminal Con-
nectors for the Ethernet Cabling
.
8) Reseat ExtIO housing into the back and
tighten the screws: Close the ExtIO housing
again by reseating the ExtIO's top into the
back. To do so, properly align the two arrows
at the rims of the top and the back. Before
closing the ExtIO housing, make sure that all
cables are running properly inside of the
housing.
The back of the ExtIO also has a mark for the
speaker. This mark shows the proper position
of the two housing parts towards one an-
other.
Make absolutely sure that top of housing is properly seated in the back all
around the housing (firmly press the top into the back). This will guarantee
the weatherproofness (IP65) of the ExtIO. Fasten the ExtIO's back using the
two Fillister head screws in the corresponding holes. Use a suitable Phillips
screwdriver for this task. Finally make sure that all rubber plugs in the ExtIO's
back are firmly in place and that they seal off the housing properly.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
43/76
MOBOTIX ExtIO User Manual
Mark for speaker inside
the back
Maximum torque for all
screws is 1 to 1.2Nm
(0.74lbf ft)
Insert cable into ExtIO's back and
close off with rubber plug
Lock cable in place with cable clamp
Insert the wires
Assemble ExtIO housing
Align arrows