User manual

2.5.4 USB Connection to a M12 Camera
1) Unscrew the upper Allen screw in the foot of
the mount, which holds the turn/tilt unit in
place (5mm Allen wrench). Remove the Allen
screw, the washer and the hex nut from the
mount.
2) Remove the cover.
3) Gently pull the turn/tilt unit and the installed
network cable out of the opening of the
mount.
4) Remove the Allen screw of the bottom cover
and take off the cover.
5) Remove the blue plug labeled RS-232 from
the insect protection.
Caution: MOBOTIX M12 cameras feature a pre-installed insect protection,
which effectively prevents small animals from entering the camera. Make
sure that the condensation escape vents remain open. Never push any ob-
jects into the drain holes as this may damage the plugs!
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
38/76
MOBOTIX ExtIO User Manual
USB cable (5 m/16 ft) for
MOBOTIX M12 and D12
models:
MX-CBL-HD-MU-5
5mm Allen wrench is in-
cluded in the delivery of
the M12 cameras
Remove Allen screw,
washer and hex nut
Pull out turn/tilt unit
Condensation escape vents
(do not block or damage)
Remove the cover
Remove RS232 plug
Remove bottom cover