User manual

2.5.2 USB Connection to a D22M Camera
1) Remove one of the rubber plugs in the back
of the D22M camera housing. This plug will
not be used any more in the course of the in-
stallation process.
2) Guide the MOBOTIX D22M USB cable with
the angled Mini USB plug first from the open-
ing in the back and under the lens mount.
3) Insert the Mini USB plug into the Mini USB/
MOBOTIX Bus connector at the front of the
lens mount. Make sure that you do not insert
the plug into the audio connector by acci-
dent.
4) Close off the opening in the back of the
D22M camera housing by properly inserting
the rubber plug that is attached to the MO-
BOTIX D22M USB cable into its seating. Make
sure that about 12cm/5in of free cable re-
main in the camera.
It is very important that the rubber plug relia-
bly protects the housing against moisture.
This will guarantee the weatherproofness
(IP65) of the camera. Please only use the pre-
installed rubber plug of the cable.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
35/76
MOBOTIX ExtIO User Manual
USB cables for
MOBOTIX D22M models:
MX-CBL-MU-MU-1
(1 m/3 ft)
MX-CBL-MU-MU-5
(5 m/16 ft)
Remove rubber plug
Guide USB cable through here
Insert USB plug into USB connector
Close off opening with rubber plug
Caution
Please only use the rubber plug that is attached to the MOBOTIX
D22M USB cable! This will guarantee the weatherproofness (IP65)
of the camera.