Specifications

66/148
M15 Camera Manual: Installation
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
Procedure
1. Place the camera face-down on a clean and dry
surface.
2. Remove the two rubber plugs at the back of the
camera housing.
3. Using the supplied 5 mm Allen wrench, loosen
the two bolts at the back of the camera housing.
Leave the bolts and washers in the camera housing.
4. Using the Allen wrench, cautiously push from
behind
in an alternating fashion onto the left and
the right bolt (red arrow in upper figure) and push
the front element out of the front of the housing.
5.
Tilt the front element forward as shown in the figure.
2.2.3 Installing the Security Clips (Optional, Not Required for M15D Kits)
The security clips are protecting the sensor modules or
the blind module in the front element of the M15 against
unwanted rotation (e.g., due to vibration when mounted
on a pole or in an automotive scenario).
Procedure
1.
Open camera housing: Open the camera housing
as described in Section 2.2.2 .
2.
Insert the security clips: To protect the modules
against unwanted rotation insert the two red secu-
rity clips at the insides of the sensor modules (as
shown in the figure). Make sure that the security
clips click into place as shown in the image detail.
3.
Close camera housing: Close the camera housing
as described in Section 2.2.8 .
Remove rubber plugs at
the back of the housing
using small screwdriver
Not required with M15D
Kit (see
Section 1.3.6 )