User manual

2.15.2 Mounting the Pole Mount and the Camera
Use the supplied stainless steel straps (item15) for affixing the pole mount to the
pole.
•Guide the connector cables of the camera
from behind through the opening at the cen-
ter of the pole mount. In order to properly
protect the cabling, you should let the cab-
ling run from the inside of the pole through
the pole mount directly into the camera.
Note: The cable to the camera should be
running at least 50cm (20") outside of the
pole!
• Guide the stainless steel straps (item15)
through the pole mount (see figure). The
stainless steel straps allow attaching the
mount to poles with diameters between 60
and 180mm (2.4" to 7.1").
• Firmly tighten the screws of the stainless
steel straps.
• Unscrew the upper Allen screw in the foot of
the mount, which holds the turn/tilt unit in
place (5mm Allen wrench, item3). Remove
the Allen screw, washer and hex nut from the
mount and pull out the turn/tilt unit out of the
mount's foot. Remove the Allen screw of the
bottom cover and take off the cover.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
49/92
M12 Camera Manual Part 1