User manual

2.12.3 Connecting Another Cable (ISDN/RS232)
In order to connect another cable besides the Ethernet cable (ISDN/RS232), it is ne-
cessary to open the bottom cover of the SecureFlex wall mount and to install the
additional cables:
• Unscrew the Allen screw of the bot-
tom cover using the supplied 5mm
Allen wrench (item3) and remove
the bottom cover, including the Allen
screw and the washer.
• Guide the additional cable from be-
low through the camera holder, the
turn/tilt unit and the foot to the back
of the foot (depending on the positi-
on of the wall/ceiling mount, it may
help to remove the cover; see also
section 2.11.3,
Converting the Wall
Mount to Ceiling Mount
).
• Remove the corresponding rubber
plug and push the cable into the
connector of the camera.
• Reseat the bottom cover and fasten the Allen screw and the washer.
• Mark the cable connector on the other end to prevent confusion about the
cable's position in the camera.
2.12.4 Inserting an SD Card (Optional)
The MOBOTIX M12 can use an SD card for storing events (available in future ver-
sions, after updating the software).
• Remove the bottom cover of the Se-
cureFlex mount.
• Remove the cables (ISDN/Ethernet/
power supply).
• Remove the insect protection.
• Insert the SD card until you feel a
stop (see figure).
• After inserting the SD card, re-insert
the insect protection and the cables
and re-install the bottom cover of
the SecureFlex mount.
To remove the SD card, gently press the
card into the camera casing. The card
pops out, allowing you to pull it out of the
camera.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
41/92
M12 Camera Manual Part 1
ISDN
Ethernet/power supply
Insect protection
Easy installation of additi-
onal cables (e.g. ISDN/
RS232/MX Interface
Connector cable)
SD cards will be suppor-
ted after installing a soft-
ware update (supported in
future versions)