User manual

3.2 Overview of the Configuration Settings
Using the Quick Installation wizard
After booting the camera for the first time or after resetting it to factory defaults,
any access to the administration menu (Admin Menu button) will start the Quick
Installation.
This wizard will guide you through the most important settings of the camera (con-
figuration of the network interface, image control, etc.) and can also be used to
reset the camera to its factory settings.
It is also recommended to use Admin Menu> Quick Installation later on as well,
e.g. if you would like to change connection parameters or add a new connection
type.
Administration and setup of the camera
Basic configuration tasks of the camera (e.g. passwords, interfaces, software
updates) are carried out from the administration menu (Admin Menu button),
which requires the corresponding access rights (
admins group).
Open the Setup Menu (button) and find the dialogs for changing the image, event
and recording settings in the Image Control and Event Control sections. These
options are also available for users belonging to the
users group.
Some of these settings can be changed using the corresponding pull-down menus
above the image on the Live screen.
The image settings are already optimized
The factory image settings of MOBOTIX cameras deliver excellent images for most
application scenarios and should not be changed. If you do wish to make changes,
your changes should be minor and gradual. Use the options of the Image Pro-
grams Quick Control for easily and quickly adjusting the camera to the current
application scenario, since the image programs perform several configuration
steps at once. For additional information on the image programs, see section
5.5.2,
Image Programs , in the Software Manual .
If you would like to reset changes without resetting the complete configuration to
factory defaults, you can use the Factory button at the bottom of the dialog to reset
only this dialog's settings. If you would like to reset all image settings, you can do
so using the Manage Settings> Restore Image Settings Quick Control above the
image on the Live screen.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
76/104
D22M Camera Manual Part 1
Always use Quick Instal-
lation for initial configu-
ration!
Admin Menu
User: admin
Password: meinsm
Setup Menu
Recommendation: Always
use factory image set-
tings!