Technical data
96/132
D14D Camera Manual: Operating The Camera
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
3.2.5 Starting the Camera With The Factory IP Address
Under certain circumstances, you may have to reset the camera to its factory IP address.
This could be the case, for example, if the IP address has been lost or the camera does
not respond to the last known IP address.
1. If the camera is powered on, disconnect the power supply by unplugging the
corresponding cables and then reconnect the power supply.
2. After about ten seconds, the LEDs will light up and blink for about four seconds.
3. After they stop blinking (all LEDs light up continuously now), hold the magnetic
side of the custom tool over the spot above the microphone labeled L in the
figure (the switch is inside the camera housing).
4. If you skip this step, disconnect the camera from the power supply and start from
the beginning.
5. Release the custom tool after around 40
seconds when the camera emits a single
sound (“boing”).
Notes
If you use the camera's L key to load the factory network configuration, this configuration
is not automatically saved in the camera's flash memory. When the camera is next
rebooted without using the L key, the last stored network configuration will be used.
To permanently store the new network configuration in the camera's flash memory,
open Admin Menu> Store.
As opposed to resetting the camera using Admin Menu > Reset configuration to
factory defaults, the user information will not be reset if the camera is booted using
the factory IP address.
Passwords and
camera settings will
not be changed
2
3
4
1
L
Users and passwords
will not be reset!
Make sure you store
the default network
conguration to the
permanent ash memory