Technical data

105/132
Image Optimization
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • [e-mail]
Using OnScreen Controls:
Camera Selection: The two rectangular checkboxes in the top right corner display which
sensor image is currently selected and can be configured. You can change the selection
by repeatedly clicking on the checkbox symbol:
• Both sensor images selected
• Only left sensor image selected
• Only right sensor image selected
Zoom in on images: You can change the zoom factor by clicking on the respective magnifying
glass symbol in the range. The eect is greater the further you click from the center of the
range. You should be able to zoom until, on the one hand, the pillow shaped-borders
caused by the distortion correction disappear (Zoom +) and, on the other hand, the objects
in the vertical center of the image are visible (Zoom –).
Moving images vertically: You can move the selected sensor image up or down by clicking
on the arrows pointing upwards and downwards in the range. The eect is greater the
further you click from the center of the range.
Moving images horizontally: You can move the selected sensor image to the left or right
by clicking on the arrows pointing left and right in the range. If both sensor images are
selected simultaneously, they can be moved away from one another by clicking on the
left side of the range and toward one another by clicking on the right side of the range.
Rotate images: You can rotate the sensor images to the left or right individually or together
synchronously by clicking on the edges of the rectangles on the bottom of the range. This
way, you can correct any oset in the lens mounts.
Horizontal image panning
Vertical image panning
Image sensor selection
Zoom
Rotate
Clicking on the central
point of the dial resets
the image to the
corresponding factory
default settings