Technical Specs
Table Of Contents
- Moblie Appearance picture
- Table of Contents
- Foreword
- 1.Quick start
- Keypad Explain
- Install SIM card
- This phone supports GSM SIM cards. Find SIM card’s
- Note：
- 1. Keep SIM card out of children’s touch.
- 2. Any abrasion or folding could easily damage SIM
- 3. Please make sure that you have cut off the powe
- Install T-flash card
- 1. First switch off the phone and remove the batte
- 2. Push the metal card holder toward the bottom of
- 3. Place the memory card into the holder with the
- Note:1.To avoid damaging memory card, please do n
- 2. Please regularly backup information in the card
- Installing Battery
- Align the battery chip with the metallic salient p
- Battery Charging
- Insert one end of the charger on the bottom of the
- Note:1. Please use the standard battery and charg
- 2.Menu functions
- 3.Accessories
- 4.FCC Regulations
- 5.SAR
- 6.Technical Specifications
13
4. FCC Regulations
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operation.
FCC ID: QPN-OGIMA
Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
---Reorient or relocate the receiving antenna.
---Increase the separation between the equipment and receiver.
---Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
---Consult the dealer or an experienced radio/TV technician for
help.
Body-worn Operation
This device was tested for typical body-worn operations. To
comply With RF exposure requirements, a minimum separation
distance of 10mm must be maintained between the user’s body