user manual

Automatic Firmware Update
Use mSetup (Tools) to automatically update the firmware. This is by far the easiest
method.
Manual Firmware Update
DO NOT PRESS ANY BUTTONS during the firmware update process.
There are two methods with which you can update the firmware.
Method 1 without pressing any buttons:
• Turn off the camera.
• Connect the camera to the computer and wait until the card is recognized as a
Removable Drive.
• Copy the new firmware files into the camera's flash card root folder.
• Disconnect the camera from the computer and wait until it turns off.
• Wait until all the LEDs are turned off.
• Connect the camera to the PC. The green LED, indicating the battery is
charging, may turn on. WAIT.
• The red LED will soon turn on and then start to blink. It may stop blinking for a
second or two. WAIT
• The firmware will be updated. This can take from a few seconds up to over two
minutes. WAIT
• The firmware files will be *automatically deleted. (* see NODELETE.bin above)
• When all LEDs (exception: green LED) have been off for 5 seconds it is safe
to disconnect the camera.
• The camera is now ready for use.
Method 2 by pressing the power button :
• Turn off the camera.
• Connect the camera to the computer and wait until the card is recognized as a
Removable Drive.
• Copy the new firmware files into the camera's flash card root folder.
• Disconnect the camera from the computer and wait until it turns off.
• Wait until all the LEDs are turned off.
• Turn on the camera and WAIT.
• The red LED will turn on for a short while and the begin to flash. WAIT.
• At times the red LED will stop flashing for a second or two. WAIT.
• The firmware will be updated. This can take from a few seconds up to over two
minutes. WAIT.
• WAIT until the red LED has been off for at least 5 seconds.
• The firmware has now been updated and the firmware file should have been
*automatically deleted. (* see NODELETE.bin above)
• The camera is now ready for use.