User guide

60
NTC-40 –HSPA+ M2M WiFi Router with Voice
YML40V
www.netcommwireless .com
NTC-40 Series – HSPA+ M2M WiFi Router
Upload
The Upload page enables you to upload firmware files or user created application packages to the NTC-40.
Figure 54 - Upload Page
The firmware of the router can be updated locally via LAN connection and also via remote access. Both upgrade types follow a
similar process.
Please note: In order to perform an update, you must be logged into the router as the root user (see the Remote
Administration section for more details).
Local firmware upgrade
The firmware update process has two steps. The first step is to upload and install the system recovery image onto the router.
You can do this by clicking on the browse button and then to navigate to where the recovery image upgrade file is located on your
computer.
Once you have selected the system recovery image file to use, click Upload to upload the file. You will then see a progress bar as
shown in the screenshot below. The upload has finished when the status bar reaches 100%.
Figure 55 - Local Firmware Upgrade - Upload Firmware
When the upload has completed, the screen should refresh and list the system recovery file you have just uploaded. Click on the
“Install” link to the right of this.
Once you should see a message reading “Done” as shown in the screenshot below.
Figure 56 - Local Firmware Upgrade - Firmware Update
Press and hold the reset button for approximately 5 – 10 seconds until the LEDs on the front of the router start to flash in an ON /
OFF sequence and then release it. The router will now boot into the system recovery mode.
The second step is to upload and install the main system software image. To do this, open your web browser (e.g. Internet
Explorer/Firefox/Safari) and navigate to http://192.168.1.1/
Click “Login” and type “root” in the Username and “admin” in the Password fields (without quotes). Then click on “Submit”.